Home
›
ENGINE ยท 1GR-FE
›
ENGINE CONTROL SYSTEM
›
ACCELERATOR PEDAL
ACCELERATOR PEDAL > INSTALLATION
for Preparation
Click here
1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY
NOTICE:
Avoid any physical impact to the accelerator pedal assembly.
Do not disassemble the accelerator pedal assembly.
Install the accelerator pedal with the 2 bolts.
Torque:
5 N*m{ 51 kgf*cm , 44 in.*lbf }
Connect the accelerator position sensor connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }