FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the tester ON.
Enter the following menus:
Select: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check the fuel operation by operating it with the Techstream.
If the fuel pump does not operate, replace the fuel pump.
| 2. CHECK FUEL PRESSURE |
Discharge the fuel system pressure.
Using a voltmeter, measure the battery voltage.
Disconnect the cable from the negative battery terminal.
Remove the fuel pipe clamp.
Disconnect the fuel hose.
![]() |
Install SST into the vehicle.
Wipe off any gasoline.
Connect the cable to the negative battery terminal.
Warm up the engine.
Turn the ignition switch OFF.
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the tester ON.
Enter the following menus:
Select: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Measure the fuel pressure.
Disconnect the Techstream from the DLC3.
Start the engine.
Measure the fuel pressure while the engine idles.
Stop the engine.
Check that the fuel pressure does not change for 5 minutes.
Discharge the fuel system pressure.
Disconnect the cable from the negative battery terminal.
Remove SST while being careful to prevent gasoline splashes.
Connect the fuel hose.
Install the fuel pipe clamp.
Connect the cable to the negative battery terminal.
| 3. CHECK FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the tester ON.
Enter the following menus:
Select: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Check that there are no leakage in the fuel system.