FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menu:
Select: Data List / Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Check the fuel operation by operating it with the Techstream.
If the fuel pump does not operate, replace the fuel pump.
| 2. CHECK FUEL PRESSURE |
Discharge the fuel pressure system (Click here).
Using a voltmeter, measure the battery voltage.
Disconnect the battery negative terminal.
Disengage the fuel pipe clamp (Click here).
Disconnect the fuel pipe No. 1.
![]() |
Install SST and the fuel tube connector onto the vehicle.
Wipe off any spilt gasoline.
Connect the cable to the battery negative terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menu:
Select: Data List / Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Measure the fuel pressure.
Enter the following menu:
Select: Data List / Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / OFF.
Check that the fuel pressure does not change for 5 minutes.
Disconnect the Techstream from the DLC3.
Disconnect the cable from the battery negative terminal.
Remove SST and the fuel tube connector while being careful to prevent gasoline splashes.
Connect the fuel tube.
| 3. CHECK FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menu:
Select: Data List / Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Check that there are no leakage in the fuel system.