Home › ENGINE ยท 2TR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE AIR FUEL RATIO SENSOR


G037926E01
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the wire harness clamp.



    G037927E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



3. REMOVE OXYGEN SENSOR


G037928E01
  1. Disconnect the heated oxygen sensor connector.

  1. Disconnect the wire harness clamp. (4WD DRIVE TYPE)



    G037929E01
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



4. REMOVE EXHAUST PIPE ASSEMBLY TAIL
  1. Remove the 2 bolts and 2 nuts.

  1. Remove the exhaust pipe tail from the 4 exhaust pipe supports.

  1. Remove the gasket from the exhaust pipe front.



5. REMOVE EXHAUST PIPE ASSEMBLY FRONT
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the exhaust pipe front from the exhaust pipe support.

  1. Remove the gasket from the exhaust manifold.