Home › ENGINE ยท 1GR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL EXHAUST PIPE ASSEMBLY FRONT
  1. Install a new gasket onto the exhaust manifold RH.

  1. Install the exhaust front pipe with the new 2 nuts.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }



2. INSTALL EXHAUST FRONT PIPE ASSEMBLY NO.2
  1. Install a new gasket onto the exhaust manifold LH.

  1. Install a new gasket onto the exhaust front pipe.

  1. Install the exhaust front pipe No. 2 onto the insulator.

  1. Install the exhaust front pipe No. 2 onto the exhaust manifold LH with the new 2 nuts.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }

  1. Install the exhaust front pipe No. 2 onto the exhaust front pipe with the 2 bolts and 2 nuts.

    Torque:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }



    G036129E02
  1. Install a new gasket onto the exhaust front pipe No. 2.

    1. Using a wooden block and plastic- faced hammer, tap in a new gasket until it is flush with the exhaust front pipe No. 2.

      NOTICE:
      1. Make sure that the gasket is in the correct direction when installing.
      2. Do not reuse the removed gasket.



3. INSTALL EXHAUST PIPE ASSEMBLY CENTER


A077857E06
  1. Check the free length.

    1. Using vernier calipers, measure the free length of the compression spring.

      Minimum:
      40.5 mm (1.594 in.)

      If the free length is less than the minimum, replace the compression spring.

  1. Install the exhaust tail pipe onto the 4 insulators.

  1. Install the exhaust pipe center onto the exhaust front pipe No. 2 with the 2 bolts and 2 springs.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



4. INSTALL HEATED OXYGEN SENSOR


  1. Using SST, install the 2 heated oxygen sensors onto the exhaust pipe.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }



    G036172E01

  1. Connect the 2 heated oxygen sensor connectors.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. CHECK FOR EXHAUST GAS LEAKAGE