Home › ENGINE ยท 1GR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE HEATED OXYGEN SENSOR
  1. Disconnect the 2 heated oxygen sensor connectors.



  1. Remove the 2 heated oxygen sensors from the exhaust pipe.


    G036127E01



3. REMOVE EXHAUST PIPE ASSEMBLY CENTER
  1. Remove the 2 bolts and 2 compression springs, then separate the exhaust pipe center.

  1. Separate the 4 insulators from the exhaust tail pipe, then remove the exhaust pipe center.



4. REMOVE EXHAUST FRONT PIPE ASSEMBLY NO.2
  1. Remove the 2 bolts and 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust front pipe.

  1. Remove the 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust manifold LH.

  1. Separate the insulator, then remove the exhaust front pipe No. 2.



5. REMOVE EXHAUST PIPE ASSEMBLY FRONT
  1. Remove the 2 nuts, then remove the exhaust front pipe.