Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. The ECM controls the vehicle's immobiliser system functions. immobiliser system data and the DTCs can be read through the vehicle's DLC3. In some cases, a malfunction may be occurring in the immobiliser system even though the security indicator light is not illuminated. When the system seems to be malfunctioning, use the Techstream to check for a malfunctions and perform repairs.


CHECK DLC3
A082779E04

Symbols (Terminals No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
  1. If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

HINT:
Connect the cable of the Techstream to the DLC3, turn the ignition switch ON, and attempt to use the tester. If the screen displays the communication error message, there is a problem either with the vehicle or with the tester.
  1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
  2. If communication is still not possible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.


INSPECT BATTERY VOLTAGE

Standard voltage:
11 to 14 V

  1. If the voltage is below 11 V, recharge or replace the battery before proceeding.