Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Enter the following menus: Body Electrical / Immobiliser / Data List.

  4. According to the display on the tester, read the "Data List".


Immobiliser 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
IG SW
Ignition switch signal/ON or OFF
ON: Ignition switch on
OFF: Ignition switch off
-
Immobiliser
Immobiliser system status/Set or Unset
Unset: Ignition switch on
Set: Without key
-
Permit (Start)
Permit (start) signal/OK or NG
OK: Engine start is permitted
NG: Engine start is not permitted
-
Response
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Frame Error
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Different Serial Number
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Different Encrypt Code
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Abnormal Status
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
BCC Malfunction
Transponder chip data/NG or OK
NG: Incorrect data being sent.
OK: Correct data being sent.
-
Sub Key
Sub key code signal/Unreg or Reg
Unreg: Non matching sub key code is sent.
Reg: Sub key code is sent.
-
Master Key
Master key code signal/Unreg or Reg
Unreg: Non matching master key code is sent.
Reg: Master key code is sent.
-
Transponder S-code
Number of registered sub key/min. 0, max. 15
Number of registered sub key.
-
Transponder M-code
Number of registered master key/min. 0, max. 15
Number of registered master key.
-
Reg Code Spac Full
Memory space for key codes registration/No or Yes
No: More key code registration possible.
Yes: No more key code registration possible.
-
+B
Power source/Break or Normal
Break: Power source open.
Normal: Power source normal.
-
Antenna Coil Status
Antenna coil condition/Normal or Fail
Normal: Antenna coil is normal.
Fail: Antenna coil is malfunctioning.
-
G-Code Support
G code judgment/Not Support or Support
Not Support: G-code is not supported
Support: G-code is supported
-
G-Code Decision
G code judgment/Yes or No
-
-
Wireless C-Code
Reg or Unreg
-
-

PERFORM ACTIVE TEST

HINT:
Perform the Techstream Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Perform the Active Test according to the display on the tester.


Transponder key ECU 
Tester Display
Test Part
Control Range
Diagnostic Note
Security Indicator
Security indicator
ON or OFF
-