YAW RATE AND DECELERATION SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Bench Seat Type) |
![]() |
Slide the front seat to the most forward position.
Disengage the hook.
Disconnect the 2 connectors.
Using a clip remover, remove the wiring harness clamp.
Remove the wiring harness clamp.
Remove the bolt and the front seat inner belt.
| 4. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Bench Seat Type) |
![]() |
Slide the front seat to the most forward position.
Disengage the hook.
Disconnect the connector.
Using a clip remover, remove the wiring harness clamp.
Remove the wiring harness clamp.
Remove the bolt and the front seat inner belt.
| 5. REMOVE FRONT SEAT HEADREST ASSEMBLY (for Bench Seat Type) |
![]() |
Push in the 2 lock buttons of the 2 front seat headrest supports and remove the 2 front seat headrests.
| 6. REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type) |
![]() |
Remove the belt of the front center seat outer belt from the front center seat outer belt guide.
![]() |
Disconnect the 5 connectors.
Using a clip remover, remove the 2 wiring harness clamps.
![]() |
Remove the 4 bolts and the front seat.
| 7. REMOVE SEAT TRACK COVER (for Separate Seat Type) |
![]() |
Disengage the 2 claws and remove the seat track cover.
| 8. REMOVE FRONT SEAT ASSEMBLY (for Separate Seat Type) |
![]() |
Disconnect the 2 connectors.
Disconnect the airbag connector.
Using a clip remover, remove the wire harness clamp.
![]() |
Remove the 4 bolts and front seat.
| 9. REMOVE FRONT FLOOR FOOTREST |
![]() |
Disengage the 2 clips and remove the front floor footrest.
| 10. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
![]() |
Disengage the 8 claws and clip, and remove the front door scuff plate.
| 11. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab) |
![]() |
Disengage the 9 claws and clip, and remove the front door scuff plate.
| 12. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab) |
![]() |
Disengage the 9 claws and remove the front door scuff plate.
| 13. REMOVE COWL SIDE TRIM BOARD LH (for Regular Cab) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 14. REMOVE COWL SIDE TRIM BOARD LH (for Access Cab) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 15. REMOVE COWL SIDE TRIM BOARD LH (for Double Cab) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 16. REMOVE SENSOR BRACKET |
![]() |
Turn up the floor carpet.
Remove the wire harness clamp.
Remove the bolt and bracket.
| 17. REMOVE YAW RATE SENSOR |
![]() |
Disconnect the yaw rate sensor connector.
Remove the 2 bolts and yaw rate sensor.