Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC
Component
Fail-Safe Operation
Fail-Safe Deactivation Condition
P0011
VVT system
  1. Idle up (Control of combustion worsening)
  2. Stopping fuel-cut control
Pass condition detected
P0031 and P0032
Air fuel ratio sensor heater
ECM turns off air fuel ratio sensor heater.
Ignition switch off
P0037 and P0038
Heated oxygen sensor heater
ECM turns off heated oxygen sensor heater
Ignition switch off
P0102 and P0103
Mass air flow meter
ECM calculates ignition timing according to engine speed and throttle valve position.
Pass condition detected
P0110, P0112 and P0113
Intake air temperature sensor
ECM estimates intake air temperature to be 20°C (68°F).
Pass condition detected
P0115, P0117 and P0118
Engine coolant temperature sensor
ECM estimates engine coolant temperature to be 80°C (176°F).
Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
Electronic Throttle Control System (ETCS)
ECM cuts off throttle actuator current and throttle valve returned to 6.5° throttle position by return spring.
ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle, to allow vehicle to continue at minimal speed.*1
Pass condition detected and then ignition switch turned off
P0327 and P0328
Knock sensor
ECM sets ignition timing to maximum retard.
Ignition switch off
P0300, P0301, P0302, P0303 and P0304*2
  1. Fuel injector
  2. Electronic Throttle Control System (ETCS)
When misfire occurs, fuel cut is performed for catalyst overheat malfunction prevention
  1. During normal load and normal engine speed (MIL is blinking) - Fuel cut is performed on malfunctioning cylinder
  2. During high load and high engine speed (MIL is blinking) - Throttle valve opening angle control is performed - All cylinder fuel cut or malfunction cylinder fuel cut
Pass condition detected and then ignition switch turned off
P0351 to P0354
Igniter
ECM cuts fuel.
Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
Accelerator pedal position sensor
Accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, ECM controls engine using other circuit.
If both circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles.
Pass condition detected and then ignition switch turned off
NOTE:
  1. *1: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.
  2. *2: Misfire related fail-safe operations occur when catalyst overheat malfunctions occur.