FUEL PRESSURE PULSATION DAMPER > INSTALLATION |
| 1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
![]() |
Apply a light coat of gasoline or spindle oil to the O-ring.
![]() |
Install the fuel pressure pulsation damper with the 2 bolts.
| 2. CONNECT FUEL HOSE |
![]() |
Align the fuel hose connector with the pipe stem, and insert the fuel hose until the retainer makes a "click" sound.
Push down the checker of the fuel hose.
Push the fuel hose down until the checker of the fuel hose makes a "click" sound.
| 3. CHECK FOR FUEL LEAKAGE |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the tester ON.
Enter the following menus:
Select: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Check that there are no leakage in the fuel system.