Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > INSTALLATION

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
  1. Check that the front wheels are facing straight ahead.



2. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Set the turn signal switch in neutral position.

    NOTICE:
    Make sure of the neutral position since the pin of the turn signal switch may be snapped.

  1. Install the spiral cable sub-assembly with the 4 screws.

    NOTICE:
    When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the handle.

  1. Connect the airbag connector and connector.

  1. Install the steering column cover with the 3 screws.



3. CENTER SPIRAL CABLE
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the negative battery terminal.

    NOTICE:
    Do not start the operation for 90 seconds after disconnecting the cable from the negative battery terminal.



    F051312
  1. Turn the cable counterclockwise by hand until it becomes harder to turn.



    F051313E01
  1. Turn the cable clockwise about 2.5 turns to align the marks.

    HINT:
    The cable will rotate about 2.5 turns both left and right from the center.



4. INSTALL UPPER STEERING COLUMN COVER
  1. Engage the claw, then install the upper steering column cover.



5. INSTALL LOWER STEERING COLUMN COVER
  1. Engage the 2 claws.

  1. Install the lower steering column cover with the 2 screws.



6. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



7. INSTALL STEERING PAD


E212028E01
Text in Illustration 
*1
Locking Button
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Connect the 2 airbag connectors.

    NOTICE:
    1. Do not damage the airbag wire harness when connecting the airbag connector.
    2. Be sure to only connect the connectors to each corresponding color.
    3. Securely lock the 2 locking buttons.

  1. Connect the horn terminal.

  1. Install the steering pad.



    E212029
  1. Using T30 "TORX" socket wrench, tighten the 2 bolts.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.



8. INSTALL NO.2 LOWER STEERING WHEEL COVER
  1. Engage the 2 claws to install the lower No. 2 steering wheel cover.



9. INSTALL NO.3 LOWER STEERING WHEEL COVER

HINT:
Use the same procedure as for the lower No. 2 steering wheel cover.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



11. INSPECT HORN BUTTON ASSEMBLY


12. INSPECT SRS WARNING LIGHT
(Click here)