Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > REMOVAL

for Preparation Click here


HINT:
COMPONENTS: Click here



1. PRECAUTION


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE NO.2 LOWER STEERING WHEEL COVER


E212024E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the lower No. 2 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape



5. REMOVE NO.3 LOWER STEERING WHEEL COVER

HINT:
Use the same procedure as for the lower No. 2 steering wheel cover.



6. REMOVE STEERING PAD
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    E212025
  1. Using T30 "TORX" socket wrench, loosen the 2 bolts completely.

  1. Pull the steering pad toward rear.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    E212026E01
  1. Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.

  1. Disconnect the 2 airbag connectors.

    NOTICE:
    When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Locking button



    E212027
  1. Disconnect the horn terminal to remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


F044997E01
  1. Remove the steering wheel assembly set nut.

  1. Place matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE LOWER STEERING COLUMN COVER


F051318E01
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the steering column cover lower.



9. REMOVE UPPER STEERING COLUMN COVER


F051319E01
  1. Disengage the claw, then remove the upper steering column cover.



10. REMOVE SPIRAL CABLE SUB-ASSEMBLY


F051337E01
  1. Disconnect the airbag connector and the connector from the spiral cable sub-assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag with harness.

  1. Disengage the 3 claws and remove the spiral cable sub-assembly.