Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for Double Cab)

SIDE AIRBAG SENSOR (for Double Cab) > INSTALLATION

for Preparation Click here


HINT:
Use the same procedures for the RH side and LH side.



1. INSTALL SIDE AIRBAG SENSOR
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    After disconnecting the cable from the terminal, wait for at least 90 seconds before starting the operation.

  1. Install the side airbag sensor with the bolt.

    Torque:
    :
    9.0 N*m{ 80 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Installation of the connector is done with the sensor assembly installed. Make sure that the sensor assembly is installed to the specified torque.
    2. If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
    3. When installing the sensor assembly, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.
    4. After installation, shake the sensor assembly to check that it is not loose.

  1. Check that there is no slack in the installation parts of the side airbag sensor.

  1. Connect the connector to the side airbag sensor.



2. INSTALL CENTER PILLAR LOWER GARNISH LH
  1. Engage the 2 claws and 2 clips, and install the center pillar lower garnish.

  1. Install the floor anchor of the front seat outer belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }



3. INSTALL LAP BELT OUTER ANCHOR COVER

HINT:
Follow the same procedures as for the opposite side.

  1. Engage the 3 claws and install the lap belt outer anchor cover.



4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Install the rear door opening trim weatherstrip.



5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Install the front door opening trim weatherstrip.



6. INSTALL REAR DOOR SCUFF PLATE LH
  1. Engage the 8 claws and install the rear door scuff plate.



7. INSTALL FRONT DOOR SCUFF PLATE LH
  1. Engage the 9 claws and install the front door scuff plate.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



9. INSPECT SRS WARNING LIGHT
Inspect the SRS warning light (Click here).