CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION |
| 1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is turned to OFF.
Check that the cable is disconnected from the battery negative terminal.
Provisionally install the air bag sensor assembly center with the 3 bolts.
Tighten the 3 bolts to the specified torque.
Check that there is no slack in the installation parts of the center airbag sensor assembly.
Connect the holder (with connectors) to the center airbag sensor assembly.
Check that the waterproof sheet is properly set.
| 2. INSTALL FRONT CONSOLE BOX (for Manual Transmission on Bench Seat Type) |
Engage the 2 clips and claw, and install the front console box.
Install the clip and 2 bolts <A>.
![]() |
Install the 2 instrument panel cup holders.
Install the box bottom mat.
Install the shift knob.
| 3. INSTALL FRONT CONSOLE BOX (for Automatic Transmission on Bench Seat Type) |
Engage the 2 clips and claw, and install the front console box.
Install the clip and 2 bolts <A>.
![]() |
Install the 2 instrument panel cup holders.
Install the box bottom mat.
Install the shift knob.
| 4. INSTALL FRONT CONSOLE BOX (for Manual Transmission on Separate Seat Type) |
![]() |
Engage the 2 clips and claw, and install the front console box.
Install the 2 screws <F>.
Install the shift knob.
| 5. INSTALL FRONT CONSOLE BOX (for Automatic Transmission on Separate Seat Type) |
Engage the 2 clips and claw, and install the front console box.
Install the 2 screws <F>.
| 6. INSTALL INSTRUMENT PANEL CUP HOLDER TRAY (for Automatic Transmission on Separate Seat Type) |
Engage the 2 clips and 4 claws, and install the instrument panel cup holder tray.
Install the 2 instrument panel cup holders.
| 7. INSTALL REAR CONSOLE BOX ASSEMBLY (for Separate Seat Type) |
![]() |
Engage the 4 claws and install the console box rear.
Install the 2 screws <F> and 2 bolts <B>.
Install the console box carpet.
| 8. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Manual Transmission on Separate Seat Type) |
Engage the 4 clips and claw, and install the console upper panel sub-assembly.
| 9. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Automatic Transmission on Separate Seat Type) |
![]() |
Engage the 6 clips and claw, and install the console upper rear panel.
Install the shift knob.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSPECT SRS WARNING LIGHT |