Home › INTRODUCTION › INTRODUCTION › REPAIR INSTRUCTION

REPAIR INSTRUCTION > CUSTOMIZE PARAMETERS


HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.


SEAT BELT WARNING SYSTEM

HINT:
The following item can be customized without using a Techstream.


Seat Belt Warning 
Item
Default
Contents
Setting
Seat belt warning buzzer
b-on
Function to turn on/off the seat belt warning buzzer
b-on, b-off

WIRELESS DOOR LOCK CONTROL SYSTEM

NOTICE:
If the battery is disconnected, the wireless answer-back buzzer will be returned to the default setting.


Wireless Door Lock 
Item
Function
Default Setting
Customized Setting
Wireless remote control
Operation signal (Buzzer)
ON
OFF
  1. Open the driver side door and insert the key into the ignition cylinder.

  2. Remove the key from the ignition cylinder and, within 5 seconds, reinsert the key and turn the ignition switch to ON.

  3. After 10 seconds, the system enters answer-back buzzer switching mode.

  4. Within 10 seconds after answer-back buzzer switching mode is started, if a transmitter button (the same button) is pressed twice, the answer-back buzzer setting changes (off to on, or on to off) to activate or disable answer-back by buzzer.

    HINT:
    1. The driver side door is closed.
    2. The ignition switch is turned off.
    3. The key is removed from the ignition cylinder.
    4. A transmitter button is not pressed for 10 seconds after answer-back switching mode is started.
    5. The transmitter is operated but the second button pressed is different from the first.
    6. Answer-back starts.