COOLING SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLING SYSTEM FOR LEAKAGE |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Pump it up to 118 kPa (1.2 kgf/cm2, 17.1 psi) and check that the pressure does not drop.
| 2. CHECK ENGINE COOLANT LEVEL AT RESERVOIR |
Check that the coolant level in the reservoir tank is between the FULL and LOW lines when the engine is cold.
If low, check for leakage and add Toyota Super Long Life Coolant or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology up to the FULL line.
| 3. CHECK ENGINE COOLANT QUALITY |
Remove the radiator cap.
Check that there are no excessive deposits of rust or scale around the radiator cap or radiator filler hole.
If excessively dirty, replace the coolant.
Attach the radiator cap.