Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR

BRAKE ACTUATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for 2TR-FE)


G037934E01
  1. Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Loosen the hose clamp bolt, then disconnect the air cleaner hose No. 1.

  1. Disconnect the 2 air cleaner clamps.

  1. Remove the air cleaner cap together with the air cleaner hose No. 1.



4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for 2TR-FE)


5. REMOVE AIR CLEANER CASE (for 2TR-FE)
  1. Remove the 3 bolts, then remove the air cleaner case.



6. REMOVE AIR INJECTION CONTROL DRIVER (for 2TR-FE)


C187274
  1. Disconnect the 2 connectors.



    C187275
  1. Remove the 2 bolts and air injection control driver.



7. REMOVE BRAKE ACTUATOR ASSEMBLY


C187257
  1. Release the connector lock lever.

  1. Disconnect the brake actuator connector.



    C187277
  1. Using a union nut wrench, separate the 6 brake tubes from the brake actuator.



    C187259E01
  1. Use tags or labels to identify the place to reconnect each brake tube.



    C187260
  1. Remove the 3 nuts and brake actuator with bracket.



8. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY


    C187276
  1. Remove the 3 bolts and actuator bracket.