FRONT AIRBAG SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE RADIATOR GRILLE |
![]() |
Remove the 2 screws.
Using a clip remover, remove the 2 clips.
Disengage the 8 guides and remove the radiator grille.
| 4. REMOVE FRONT AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Remove the 2 bolts.
Disengage the 2 claws to separate the front airbag sensor.
![]() |
Disconnect the connector from the front airbag sensor.
Push down the white housing lock and slide the yellow CPA (At this time, the connector cannot be disconnected yet).

| *1 | Housing Lock | *2 | CPA |
| *a | Connector Lock is Released | - | - |
Push down the white housing lock again and disconnect the connector and remove the front airbag sensor.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.
