Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRUISE CONTROL MAIN SWITCH


    E076133E01
  1. Install the cruise control main switch with the 2 screws and connect the connector.



2. INSTALL STEERING PAD ASSEMBLY


E212028E01
Text in Illustration 
*1
Locking Button
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Connect the 2 airbag connectors.

    NOTICE:
    1. Do not damage the airbag wire harness when connecting the airbag connector.
    2. Be sure to only connect the connectors to each corresponding color.
    3. Securely lock the 2 locking buttons.

  1. Connect the horn terminal.

  1. Install the steering pad.



    E212029
  1. Using T30 "TORX" socket wrench, tighten the 2 bolts.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.



3. INSTALL LOWER NO. 3 STEERING WHEEL COVER

HINT:
Use the same procedure as for the lower No. 2 steering wheel cover.



4. INSTALL LOWER NO. 2 STEERING WHEEL COVER
  1. Engage the 2 claws to install the lower No. 2 steering wheel cover.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSPECT STEERING PAD ASSEMBLY


7. INSPECT SRS WARNING LIGHT
(Click here)