Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least for 90 seconds after disconnecting the cable to prevent the airbag from working.


3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


E212024E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the lower No. 2 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape



4. REMOVE LOWER NO. 3 STEERING WHEEL COVER

HINT:
Use the same procedure as for the lower No. 2 steering wheel cover.



5. REMOVE STEERING PAD ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    E212025
  1. Using T30 "TORX" socket wrench, loosen the 2 bolts completely.

  1. Pull the steering pad toward rear.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    E212026E01
  1. Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.

  1. Disconnect the 2 airbag connectors.

    NOTICE:
    When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Locking button



    E212027
  1. Disconnect the horn terminal to remove the steering pad.



6. REMOVE CRUISE CONTROL MAIN SWITCH


    E076133E01
  1. Disconnect the connector and remove the 2 screws.



    E076134E01
  1. Remove the cruise control main switch from the steering wheel.