ECM > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
Disengage the claw and separate the glove compartment door stopper from the glove compartment door assembly.
Slightly deform the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.
![]() |
Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.
Remove the glove compartment door stopper.
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER RH |
![]() |
Remove the bolt <B>.
Disengage the 2 clips and remove the instrument panel lower finish panel sub-assembly RH.
| 4. REMOVE ECM |
![]() |
Disconnect the 4 connectors.
Remove the 2 bolts and nut, then remove the ECM.
| 5. REMOVE ECM BRACKET |
![]() |
Remove the 3 screws, then remove the ECM bracket.
| 6. REMOVE ECM BRACKET NO.2 |
![]() |
Remove the 2 screws, then remove the ECM bracket No. 2.