AUTOMATIC TRANSMISSION SYSTEM > CHECK MODE PROCEDURE |
| DESCRIPTION |
| CHECK MODE PROCEDURE |
Make sure that the following conditions are met:
Battery positive voltage is 11 V or higher.
Throttle valve is fully closed.
Shift lever is in P or N.
A/C is off.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
![]() |
Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.
Start the engine. The MIL should turn off after the engine starts.
Perform "Monitor Drive Pattern" for the ECT test (Click here), or reproduce the conditions of the malfunction described by the customer.
After reproducing the malfunction conditions, use the Techstream to check the DTCs and freeze frame data.