Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST

for Preparation Click here



PERFORM HYDRAULIC TEST


  1. Measure the line pressure.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature of 50 to 80°C (122 to 176°F).
    2. The line pressure test should always be carried out in pairs. One technician should observe the condition of the wheels or wheel stoppers from outside the vehicle while the other is doing the test.
    3. Be careful to prevent SST's hose from interfering with the exhaust pipe.
    4. This check must be conducted after checking and adjusting the engine.
    5. Perform the test with the A/C OFF.
    6. Do not conduct stall tests for longer than 5 seconds continuously.


    1. Warm up the ATF.

    2. Turn the ignition switch OFF.

    3. Lift the vehicle up.



    4. G023738E03
    5. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09992-00095   (09992-00231, 09992-00271)

    6. Lower the vehicle.

    7. Fully apply the parking brake and chock the 4 wheels.

    8. Start the engine and check the idling speed.

    9. Keep your left foot pressing firmly on the brake pedal and shift into the D position.

    10. Measure the line pressure while the engine is idling.

    11. Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.

    12. In the same manner, do the test in the R position.

      Specified line pressure:

      Condition
      D position: kPa (kgf/cm2, psi)
      R position: kPa (kgf/cm2, psi)
      Stall test
      1100 to 1250 (11.2 to 12.7, 159.5 to 181.3)
      1300 to 1700 (13.2 to 17.3, 188.5 to 246.5)


      Evaluation:

      Problem
      Possible cause
      If the measured values at all positions are too high
      1. Shift solenoid valve (SLT) defective
      2. Regulator valve defective
      If the measured values at all positions are too low
      1. Shift solenoid valve (SLT) defective
      2. Regulator valve defective
      3. Oil pump defective
      4. O/D direct clutch defect
      If pressure is low in the D position only
      1. D position circuit fluid leakage
      2. Forward clutch defective
      If pressure is low in the R position only
      1. R position circuit fluid leakage
      2. Direct clutch defective
      3. 1st and reverse brake defective