DTC P0973 Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1) |
DTC P0974 Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1) |
DTC P0976 Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2) |
DTC P0977 Shift Solenoid "B" Control Circuit High (Shift Solenoid Valve S2) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0973 | ECM detects short in solenoid valve S1 circuit 2 times when solenoid valve S1 is operated. (1-detection logic) |
|
| P0974 | ECM detects open in solenoid valve S1 circuit 2 times when solenoid valve S1 is not operated. (1-detection logic) |
|
| P0976 | ECM detects short in solenoid valve S2 circuit 2 times when solenoid valve S2 is operated. (1-trip detection logic) |
|
| P0977 | ECM detects open in solenoid valve S2 circuit 2 times when solenoid valve S2 is not operated. (1-trip detection logic) |
|
| Related DTCs | P0973: Shift solenoid valve S1/Range check (Low resistance) P0974: Shift solenoid valve S1/Range check (High resistance) |
| Required sensors/Components | Shift solenoid valve S1 |
| Frequency of operation | Continuous |
| Duration | 0.128 seconds or more |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| Related DTCs | P0976: Shift solenoid valve S2/Range check (Low resistance) P0977: Shift solenoid valve S2/Range check (High resistance) |
| Required sensors/Components | Shift solenoid valve S2 |
| Frequency of operation | Continuous |
| Duration | 0.128 seconds or more |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present. | None |
| Solenoid | ON |
| The monitor will run whenever the following DTCs are not present. | None |
| Solenoid | OFF |
| The monitor will run whenever the following DTCs are not present. | None |
| Solenoid | ON |
| The monitor will run whenever the following DTCs are not present. | None |
| Solenoid | OFF |
| Intelligent power MOS diagnosis fail signals detected while the solenoid is operated | Fail: Solenoid resistance 8 Ω or less |
| Intelligent power MOS diagnosis fail signals detected while the solenoid is not operated | Fail: Solenoid resistance 100 kΩ or more |
| Intelligent power MOS diagnosis fail signals detected while the solenoid is operated | Fail: Solenoid resistance 8 Ω or less |
| Intelligent power MOS diagnosis fail signals detected while the solenoid is not operated | Fail: Solenoid resistance 100 kΩ or more |
| Shift solenoid valve S1 resistance | 11 to 15 Ω at 20°C (68°F) |
| Shift solenoid valve S2 resistance | 11 to 15 Ω at 20°C (68°F) |

| Gear shift controlled by ECM | 1st | 2nd | 3rd | 4th |
| Shift solenoid valve S1 | ON | ON | OFF | OFF |
| Shift solenoid valve S2 | OFF | ON | ON | OFF |
| 1.INSPECT TRANSMISSION WIRE (S1/S2) |
![]() |
Disconnect the transmission wire connector from the transmission.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 4 - Body ground | 11 to 15 Ω at 20°C (68°F) |
| 8 - Body ground | 11 to 15 Ω at 20°C (68°F) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Connect the transmission connector to the transmission.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E5-9 (S1) - Body ground | 11 to 15 Ω at 20°C (68°F) |
| E5-8 (S2) - Body ground | 11 to 15 Ω at 20°C (68°F) |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE (S1/S2) |
![]() |
Remove the shift solenoid valve S1 or S2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| Solenoid Connector (S1) - Solenoid Body (S1) | 11 to 15 Ω at 20°C (68°F) |
| Solenoid Connector (S2) - Solenoid Body (S2) | 11 to 15 Ω at 20°C (68°F) |
Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating noise.
|
| ||||
| OK | ||
| ||