STEERING SYSTEM > REPAIR |
| 1. STEERING OFF CENTER REPAIR PROCEDURE |
![]() |
Inspect steering wheel off center.
Apply masking tape to the top center of the steering wheel and steering column upper cover.
Drive the vehicle in a straight line for 100 meters at a constant speed of 35 mph (56 km/h), and hold the steering wheel to maintain the course.
![]() |
Draw a line on the masking tape as shown in the illustration.
![]() |
Turn the steering wheel to its straight position.
Draw a new line on the masking tape or the steering wheel as shown in the illustration.
Measure the distance between the 2 lines on the masking tape of the steering wheel.
Convert the measured distance to the steering angle.
![]() |
Adjust the steering angle.
Draw a line on the RH and LH tie rods and on the RH and LH rack ends which can easily be seen.
Using a paper gauge, measure the distance from RH and LH tie rod ends to the rack end screws.
![]() |
Remove the RH and LH boot clips from the rack boots.
Loosen the RH and LH lock nuts.
Turn the RH and LH rack ends by the same amount (but in different directions) according to the steering angle.
Tighten the RH and LH lock nuts.
Install the RH and LH boot clips.