Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ASSEMBLY
  1. Inspect the voltage.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the Techstream to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the Techstream on.

    6. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

    7. Read the value displayed on the Techstream.

      Standard Voltage:
      Accelerator Pedal Operations
      Accel Sensor Out No. 1
      Accel Sensor Out No. 2
      Released
      0.5 to 1.1 V
      1.2 to 2.0 V
      Depressed
      2.6 to 4.5 V
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness and ECM.