FUEL INJECTOR > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
Check the injection volume.
Discharge the fuel system pressure (Click here).
Remove the fuel hose from the fuel pressure pulsation damper .
Remove the fuel hose from the fuel pipe (Click here).
Separate the pressure regulator .
![]() |
Assemble SST as shown in the illustration.
![]() |
Connect SST to the fuel pipe.
![]() |
Install the pressure regulator onto SST (union) with the 2 bolts.
![]() |
Install the O-ring onto the injector.
Assemble SST as shown in the illustration.
Put the injector into a graduated cylinder.
![]() |
Make sure that SST is installed as shown in the illustration.
Operate the fuel pump .
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.
![]() |
Check the leakage.
In the condition above, disconnect the tester probes of SST (wire) from the battery and check the fuel leakage from the injector.