Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA
  1. The skid control ECU stores the current vehicle (sensor) state as freeze frame data when a DTC is detected, or when the ABS, BA, TRAC or VSC are operating.
    The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the ABS, BA, TRAC or VSC was activated.

    HINT:
    1. The skid control ECU will not count the number of times the ignition switch is turned ON if the vehicle does not drive at a speed of at least 7 km/h (4.3 mph), or a DTC is detected.
    2. Freeze frame data at the time the ABS, BA, TRAC or VSC operates:
      The skid control ECU stores and updates the data whenever the ABS, BA, TRAC or VSC system operates.
      When the ECU stores data at the time a DTC is detected, the data stored when the ABS, BA, TRAC or VSC operated may be cleared.
    3. Freeze frame data at the time a DTC is detected:
      When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON.

  4. From the display on the Techstream, select the Freeze Frame Data.

    Skid Control ECU 
    Tester Display
    Measurement Item
    Reference Value
    Elapsed Time after Freeze Trigger
    Elapsed time after freeze trigger
    Min.: 0 msec., Max.: 500 msec.
    Number of IG ON
    Number of operations of ignition switch ON after storing freeze frame data
    0 to 31
    Buzzer
    Skid control buzzer signal
    OFF: Skid control buzzer off
    ON: Skid control buzzer on
    Stop Lamp SW
    Stop light switch signal
    OFF: Stop light switch off
    ON: Stop light switch on
    Parking Brake SW
    Parking brake switch signal
    OFF: Parking brake switch off
    ON: Parking brake switch on
    Gear Position
    Gear position information
    Fail
    1st
    2nd
    3rd
    4th
    5th
    6th
    7th
    P, N
    8th
    R
    Not R
    Shift Lever Position
    Shift lever position information
    Fail
    1st
    2nd
    3rd
    4th
    5th
    6th/B
    D/M
    P, N
    R
    Operated System
    Operated system status
    Non: No system activated
    ABS: ABS activated
    VSC: VSC activated
    TRAC: TRAC activated
    BA: BA activated
    HAB: HAB activated
    Fail: Fail-safe mode activated
    PBA: PBA activated
    PB: PB activated
    HA-CTRL: Hill-start assist control activated
    Sys: System prohibited
    Master Cylinder Sensor
    Master cylinder pressure sensor reading
    Min.: 0 V, Max.: 5 V
    M/C Sensor Grade
    Master cylinder pressure sensor change
    Min.: -30 MPa/s, Max.: 225 MPa/s
    Yaw Rate Sensor
    Yaw rate sensor reading
    Min.: -128°/s, Max.: 127°/s
    Lateral G
    Lateral G
    Min.: -25.10 m/s2, Max.: 24.90 m/s2
    Forward and Rearward G
    Forward and rearward G
    Min.: -25.10 m/s2, Max.: 24.90 m/s2
    FR Wheel Speed
    Front right wheel speed reading
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    FL Wheel Speed
    Front left wheel speed reading
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    RR Wheel Speed
    Rear right wheel speed reading
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    RL Wheel Speed
    Rear left wheel speed reading
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    Vehicle Speed
    Vehicle speed reading
    Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
    Vehicle Speed Grade
    Vehicle speed grade
    Min.: -25.10 m/s2, Max.: 24.90 m/s2
    FR Wheel Direction
    Front right wheel direction
    Forward: Wheel direction forward
    Back: Wheel direction back
    FL Wheel Direction
    Front left wheel direction
    Forward: Wheel direction forward
    Back: Wheel direction back
    RR Wheel Direction
    Rear right wheel direction
    Forward: Wheel direction forward
    Back: Wheel direction back
    RL Wheel Direction
    Rear left wheel direction
    Forward: Wheel direction forward
    Back: Wheel direction back
    Real Engine Torque
    Real engine torque
    Min.: -1024 Nm, Max.: 1023 Nm
    Accelerator Opening Angle %
    Accelerator opening Angle %
    min.: 0%
    max.: 128%
    Inspection Mode
    Inspection mode
    Other: Normal mode
    Inspect: Inspection mode
    Steering Angle Sensor
    Steering angle sensor reading
    Min.: -3276.8°
    Max.: 3276.7°
    TRAC/VSC Off Mode
    TRAC/VSC Off Mode
    Normal mode
    TRAC OFF mode
    VSC OFF mode