Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK COWL SIDE JUNCTION BLOCK RH ASSEMBLY (MULTIPLEX NETWORK BODY ECU)

B125008E01

  1. Disconnect the 1A, 1C, 1F, 1H, 1I, 1J, and 1K driver side J/B connectors.

  2. Measure the resistance and voltage of the wire harness side connectors.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG (1A-4) - Body ground
    L-Y - Body ground
    Ignition power supply
    Ignition switch OFF
    0 V
    Ignition switch ON
    10 to 14 V
    ECUB (1C-16) - Body ground
    R - Body ground
    +B (ECUB) power supply
    Always
    10 to 14 V
    ALTB (1A-6) - Body ground
    L - Body ground
    +B (power system, generator system) power supply
    Always
    10 to 14 V
    KSW (1K-10) - Body ground
    G-B - Body ground
    Key unlock warning switch input
    No key in ignition key cylinder
    10 kΩ or higher
    Key inserted in ignition key cylinder
    Below 1 Ω
    DCTY (1F-7) - Body ground
    G-Y - Body ground
    Driver side courtesy switch input
    Driver side door Closed
    10 kΩ or higher
    Driver side door Open
    Below 1 Ω
    PCTY (1I-8) - Body ground
    R-B - Body ground
    Passenger side courtesy switch input
    Passenger side door Closed
    10 kΩ or higher
    Passenger side door Open
    Below 1 Ω
    RCTY (1F-6) - Body ground
    P-B - Body ground
    Rear LH side courtesy switch input
    Rear LH side door Closed
    10 kΩ or higher
    Rear LH side door Open
    Below 1 Ω
    RCTY (1J-15) - Body ground
    P-B - Body ground
    Rear RH side courtesy switch input
    Rear RH side door Closed
    10 kΩ or higher
    Rear RH side door Open
    Below 1 Ω
    GND (1H-18) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the driver side J/B connectors.

  4. Measure the voltage of the connectors.


Standard: 
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
HAZ (1L-8) - Body ground
W - Body ground
Hazard light drive
Answer-back ON
Pulse generation
Answer-back OFF
10 to 14 V
RDA (B5-7) - Body ground
L - Body ground
Door control receiver input
Ignition switch off, all doors closed and transmitter switch not pressed
11 to 14 V
Ignition switch off, all doors closed and transmitter switch pressed
Pulse generation
  1. If the result is not as specified, there may be a malfunction on the driver side J/B assembly (multiplex network body ECU).