BRAKE ACTUATOR > ON-VEHICLE INSPECTION |
| 1. CONNECT TECHSTREAM |
Warm up the engine.
Turn the ignition switch to off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
| 2. INSPECT BRAKE ACTUATOR MOTOR |
With the motor relay ON, check the actuator motor operation sounds.
Turn the motor relay OFF.
Depress the brake pedal and hold it for approximately 15 seconds. Check that the brake pedal cannot be depressed further.
With the motor relay ON, check that the pedal does not pulsate.
Turn the motor relay OFF and release the brake pedal.
| 3. INSPECT BRAKE ACTUATOR SOLENOID (for Front Right Wheel) |
With the brake pedal depressed, perform the following operations.
Turn the SFRH and SFRR solenoids ON simultaneously, and check that the pedal cannot be depressed further.
Turn the SFRH and SFRR solenoids OFF simultaneously, and check that the pedal can be depressed further.
Turn the motor relay ON, and check that the pedal can be depressed.
Turn the motor relay OFF and release the brake pedal.
| 4. INSPECT BRAKE ACTUATOR SOLENOID (for Front Left Wheel) |
With the brake pedal depressed, perform the following operations.
Turn the SFLH and SFLR solenoids ON simultaneously, and check that the pedal cannot be depressed further.
Turn the SFLH and SFLR solenoids OFF simultaneously, and check that the pedal can be depressed further.
Turn the motor relay ON, and check that the pedal can be depressed.
Turn the motor relay OFF and release the brake pedal.
| 5. INSPECT BRAKE ACTUATOR SOLENOID (for Rear Right Wheel) |
With the brake pedal depressed, perform the following operations.
Turn the SRRH and SRRR solenoids ON simultaneously, and check that the pedal cannot be depressed further.
Turn the SRRH and SRRR solenoids OFF simultaneously, and check that the pedal can be depressed further.
Turn the motor relay ON, and check that the pedal can be depressed.
Turn the motor relay OFF and release the brake pedal.
| 6. INSPECT BRAKE ACTUATOR SOLENOID (for Rear Left Wheel) |
With the brake pedal depressed, perform the following operations.
Turn the SRLH and SRLR solenoids ON simultaneously, and check that the pedal cannot be depressed further.
Turn the SRLH and SRLR solenoids OFF simultaneously, and check that the pedal can be depressed further.
Turn the motor relay ON, and check that the pedal can be depressed.
Turn the motor relay OFF and release the brake pedal.