OCCUPANT CLASSIFICATION SYSTEM (for Separate Seat Type) > INITIALIZATION |
| ZERO POINT CALIBRATION |
Zero point calibration and sensitivity check procedures
Adjust the seat position in accordance with the table below.
| Adjustment Item | Position |
| Slide Direction | Rearmost position |
| Reclining Angle | Upright position |
| Headrest Height | Lowest position |
| Lifter Height | Lowest position |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Perform the zero point calibration by following the prompts on the Techstream screen.
Perform the sensitivity check by following the prompts on the Techstream screen.
Confirm that the beginning sensor reading is within the standard range.
Place a 30 kg (66.14 lb) weight (e.g. a lead mass) onto the front passenger seat.
Confirm that the sensitivity is within the standard range.