Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Inner Rear View Mirror Power Source Circuit


DESCRIPTION

This is the power source circuit of the inner rear view mirror assembly.

WIRING DIAGRAM


E236471E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BATTERY AND BODY GROUND)


    E236292E01
  1. Disconnect the I8 inner rear view mirror assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I8-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    I8-8 (+B) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I8-2 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Inner Rear View Mirror Assembly)

  1. Reconnect the inner rear view mirror assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)