Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > TERMINALS OF ECU



REAR TELEVISION CAMERA ASSEMBLY

E233219E01

  1. Disconnect the T19 rear television camera assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T19-3 (CGND) - Body ground
    L - Body ground
    Ground
    Always
    Below 1 Ω
    T19-4 (CB+) - Body ground
    B - Body ground
    Power source
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the rear television camera assembly connector.

  4. Measure the waveform according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T19-2 (CV+) - T19-1 (CV-)
    R - W
    Video signal
    Ignition switch ON, shift lever in R
    Pulse generation
    (See waveform 1)
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens
    Pulse generation
    (See waveform 2)

    HINT:
    A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.

    If the result is not as specified, the rear television camera assembly may have a malfunction.



  5. E171712E28
  6. Using an oscilloscope, check the waveform.

    HINT:
    A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.


    1. Waveform 1 (Reference)
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      T19-2 (CV+) - T19-1 (CV-)
      Tool Setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, shift lever in R

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

    2. Waveform 2 (Reference)
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      T19-2 (CV+) - T19-1 (CV-)
      Tool Setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration 
      *a
      Waveform 1
      *b
      Waveform 2
      *c
      Synchronized Signal
      *d
      Video Waveform


RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)