METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT SPEEDOMETER |
Check speedometer operation.
Before starting the following inspection, check if the Brake Control System outputs the DTCs.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Maximum wheel speed sensor reading/ Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Techstream Indication (mph) | Acceptable Range (mph) |
| 20 | 20 to 23 |
| 40 | 40 to 43.5 |
| 60 | 60 to 64 |
| 80 | 80 to 84.5 |
| 100 | 100 to 105 |
| Techstream Indication (km/h) | Acceptable Range (km/h) |
| 20 | 17.5 to 21.5 |
| 40 | 38 to 42 |
| 60 | 58 to 63 |
| 80 | 78 to 84 |
| 100 | 98.5 to 104.5 |
| 120 | 119 to 125 |
| 140 | 139 to 146 |
| 160 | 159 to 167 |
| 2. INSPECT TACHOMETER |
Check the operation.
Connect the Techstream, and start the engine.
Compare the test results with the tachometer indications.
| Techstream Indication (rpm) | Acceptable Range (rpm) Data in ( ) is for Reference |
| 700 | 630 to 770 |
| 1000 | (900 to 1100) |
| 2000 | (1850 to 2150) |
| 3000 | 2800 to 3200 |
| 4000 | (3800 to 4200) |
| 5000 | 4800 to 5200 |
| 6000 | (5750 to 6250) |
| 7000 | 6700 to 7300 |