STEERING COLUMN ASSEMBLY > REASSEMBLY |
| 1. INSTALL NO.1 TILT STEERING SUPPORT COLLAR |
Install the No. 1 tilt steering support collar from the steering column tube lower.
![]() |
Using a hammer and vise, install the steering column bracket spacer.
| 2. INSTALL STEERING MAIN SHAFT ASSEMBLY |
Install the steering main shaft onto the steering column tube upper and steering column tube lower.
![]() |
Using a snap ring expander, install a new snap ring onto the main shaft.
![]() |
Install the steering column No. 1 ring onto the steering main shaft.
| 3. INSTALL KEY INTER LOCK SOLENOID (for Automatic Transmission) |
Install the key inter lock solenoid onto the steering column bracket assembly upper with 2 screws.
| 4. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY |
Engage the ignition starter switch assembly into the steering column bracket assembly upper with the 2 claws.
| 5. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY |
Install the un-lock warning switch assembly onto the steering column bracket assembly upper.
Connect the un-lock warning switch assembly connector to the ignition switch assembly.
| 6. INSTALL IGNITION SWITCH LOCK CYLINDER & KEY SET |
Make sure that the ignition switch lock cylinder assembly is in the accessory position.
Install the ignition switch lock cylinder assembly.
| 7. INSTALL TRANSPONDER KEY AMPLIFIER |
Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.
Push up the transponder key amplifier and connect it to the upper bracket.
| 8. INSPECT STEERING LOCK OPERATION |
Check that the steering mechanism is activated when removing the key.
Check that the steering mechanism is deactivated when inserting the key and turning it to ACC position.
| 9. INSTALL UPPER STEERING COLUMN CLAMP |
Provisionally install the steering column bracket assembly upper and steering column upper clamp with the 2 new tapered-head bolts.
Tighten the 2 tapered-head bolts until the bolt heads break off.
| 10. INSTALL TILT LEVER RETURN SPRING |
![]() |
Install the tilt lever return spring onto the bracket and steering tilt lever.
| 11. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the steering intermediate shaft sub-assembly and steering main shaft assembly.
Temporarily install the steering intermediate shaft sub- assembly with the bolt.