Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Clutch Switch Circuit

for Preparation Click here


DESCRIPTION

Clutch switch circuit inspection is necessary for manual transmission vehicles.
When the clutch pedal is released, the ECM receives the positive (+) battery voltage through the IG1 No. 2 fuse and ignition switch. While the clutch pedal is depressed, the clutch switch assembly sends a signal to terminal D of the ECM. The ECM cancels cruise control when terminal D receives the signal (voltage of below 1 V).

WIRING DIAGRAM


E170560E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY)
E170561E01
  1. Disconnect the E9 or E7 ECM connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E9-27 (D) - Body ground*1
    Clutch Pedal Depressed
    Below 1 V
    E7-21 (D) - Body ground*2
    Clutch Pedal Depressed
    Below 1 V
    E9-27 (D) - Body ground*1
    Clutch Pedal Released
    11 to 14 V
    E7-21 (D) - Body ground*2
    Clutch Pedal Released
    11 to 14 V

    1. *1: for 1GR-FE
    2. *2: for 2TR-FE

  1. Reconnect the ECM connector.



OK
PROCEED TO PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT CLUTCH SWITCH ASSEMBLY


    I031382E03
  1. Remove the clutch switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C14-1 - C14-2
    Clutch pedal depressed
    10 kΩ or higher
    C14-1 - C14-2
    Clutch pedal released
    Below 1 Ω

  1. Reinstall the clutch switch.



NG
REPLACE CLUTCH SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (CLUTCH SWITCH ASSEMBLY - ECM)


    E170562E01
  1. Disconnect the E7 or E9 ECM connector.

  1. Disconnect the C14 clutch switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C14-2 - Body ground
    Always
    10 kΩ or higher
    C14-2 - E9-27 (D)*1
    Always
    Below 1 Ω
    C14-2 - E7-21 (D)*2
    Always
    Below 1 Ω

    1. *1: for 1GR-FE
    2. *2: for 2TR-FE

  1. Reconnect the clutch switch connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CLUTCH SWITCH ASSEMBLY - ECM)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (CLUTCH SWITCH ASSEMBLY - BATTERY)