FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 8 claws and clip, and remove the front door scuff plate.
| 3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Separate the front door opening trim weatherstrip to the extent which allows the removal of the quarter trim lower panel and quarter inside trim board.
| 4. REMOVE BACK PANEL TRIM COVER |
![]() |
for Separate Seat Type and Bench Seat Type:
Disengage the 6 claws and remove the back panel trim cover.
![]() |
for Bench Seat Type:
Disengage the 6 claws and remove the back panel trim cover.
| 5. REMOVE BACK PANEL UPPER GARNISH |
![]() |
Disengage the 4 claws and 5 clips, and remove the back panel upper garnish.
| 6. REMOVE JACK ASSEMBLY (for Separate Seat Type) |
| 7. REMOVE BACK PANEL TRIM COVER (for Separate Seat Type) |
![]() |
Remove the 2 clips.
Disengage the 4 claws and remove the back panel trim cover.
| 8. REMOVE BACK PANEL TRIM (for Separate Seat Type) |
![]() |
Remove the 4 clips and back panel trim.
| 9. REMOVE QUARTER TRIM LOWER PANEL |
![]() |
Disengage the 2 claws and 3 clips, and remove the quarter trim lower panel.
| 10. REMOVE QUARTER INSIDE TRIM BOARD |
![]() |
for LH Side and Separate Seat Type RH side:
Remove the bolt and the floor anchor of the front seat outer belt.
![]() |
for Bench Seat Type RH Side:
Remove the bolt and the floor anchor of the front seat outer belt.
Disconnect the belt tension sensor connector.
Remove the wiring harness clamp.
![]() |
Using a screwdriver with its tip taped in protective tape, disengage the claw and open the cover.
| *1 | Protective Tape |
![]() |
Remove the 3 screws.
Disengage the 2 clips and remove the quarter trim board.
| 11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the bolt and shoulder anchor.
![]() |
Disconnect the pretensioner connector as shown in the illustration.
Remove the 2 bolts and retractor.
| 12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Remove the bolt.
Disengage the 2 claws and remove the front shoulder belt anchor adjuster.