Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Access Cab)

FRONT SEAT OUTER BELT ASSEMBLY (for Access Cab) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B087294E01
  1. Insert the 2 claws of the front shoulder belt anchor adjuster into the hole in the body and mount the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }



2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    B087293E03
  1. Check the amount of inclination required to lock the retractor.

    1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any directions. Also check that the belt locks when the inclination of the retractor is 45° or more.

      NOTICE:
      Do not disassemble the retractor.

      If operation is not as specified, replace the front seat outer belt.



    B087295E02
  1. Hook the lower stay of the retractor onto the 2 body hooks.

  1. Tighten bolt A, and then tighten bolt B.

    Torque:
    8.5 N*m{ 85 kgf*cm , 75 in.*lbf } for bolt A
    42 N*m{ 430 kgf*cm , 31 ft.*lbf } for bolt B

  1. Connect the pretensioner connector as shown in the illustration.



    B087290E02
  1. Install the shoulder anchor with the nut.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Check that the shoulder anchor rotates smoothly.



    B088585E01
  1. Install the floor anchor of the front seat outer belt with the bolt.

  1. Check the ELR lock.

    NOTICE:
    1. The check should be performed with the front seat outer belt installed.
    2. Do not allow the anchor part of the front seat belt outer and the protruding parts of the door panel to overlap.


    1. With the belt installed, check that the belt locks when it is pulled out quickly.
      If operation is not as specified, replace the front seat outer belt.

  1. Remove the bolt and floor anchor.



3. INSTALL ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY


B088055E02
  1. Install the access panel inside handle sub-assembly LH with the 3 screws.

  1. Connect the rod.



4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B088054E01
  1. Engage the 9 clips and install the rear door trim board.

  1. Install the clip.



5. INSTALL ACCESS PANEL INSIDE HANDLE BEZEL


    B088052E01
  1. Install the access panel inside handle bezel with the screw.

  1. Close the cover.



6. INSTALL DOOR PULL HANDLE


    B088053E01
  1. Install the door pull handle with the screw.



7. INSTALL LAP BELT OUTER ANCHOR COVER


B088402E01
  1. Engage the 3 claws and install the lap belt outer anchor cover.



8. INSTALL ACCESS PANEL REAR WEATHERSTRIP


B088050
  1. Install the access panel rear weatherstrip LH.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



10. INSPECT SRS WARNING LIGHT
(Click here)