Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Access Cab)

FRONT SEAT OUTER BELT ASSEMBLY (for Access Cab) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the air bag from working.


2. REMOVE ACCESS PANEL REAR WEATHERSTRIP


B088050
  1. Remove the access panel rear weatherstrip LH.



3. REMOVE LAP BELT OUTER ANCHOR COVER


B088402E01
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



4. REMOVE DOOR PULL HANDLE


    B088053E01
  1. Remove the screw, then remove the door pull handle.



5. REMOVE ACCESS PANEL INSIDE HANDLE BEZEL


    B088051E01
  1. Using a screwdriver with its tip wrapped in protective tape, open the cover.



    B088052E01
  1. Remove the screw, then remove the access panel inside handle bezel.



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B088403E01
  1. Remove the bolt and floor anchor of the front seat outer belt.



    B088054E01
  1. Remove the clip.

  1. Disengage the 9 clips and remove the rear door trim board.



7. REMOVE ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY


B088055E01
  1. Disconnect the rod.

  1. Remove the 3 screws, and then remove the access panel inside handle sub-assembly.



8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B087290E03
  1. Remove the nut and shoulder anchor.



    B087291E01
  1. Disconnect the pretensioner connector as shown in the illustration.

  1. Remove the 2 bolts and retractor.



9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B087292E01
  1. Remove the bolt.

  1. Disengage the 2 claws and remove the front shoulder belt anchor adjuster.