Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Bench Seat Type)

FRONT SEAT INNER BELT ASSEMBLY (for Bench Seat Type) > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH


    B087535E02
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Condition
      Specified condition
      1 - 2
      Fasten seat belt
      10 kΩ or higher
      1 - 2
      Release seat belt
      Below 1 Ω

      If the result is not as specified, replace the front seat inner belt.