Home › ENGINE ยท 1GR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE V-BANK COVER


A075593E01
  1. Remove the 2 nuts, then remove the V-bank cover.



4. REMOVE AIR CLEANER ASSEMBLY


A075594E01
  1. Disconnect the ventilation hose No. 2.



    A075595E01
  1. Disconnect the vacuum hose.

  1. Disconnect the mass air flow meter connector.

  1. Remove the 2 wire harness clamps.



    A075596E01
  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts, then remove the air cleaner.



5. DISCONNECT NO.2 FUEL PIPE SUB-ASSEMBLY


A121824E01
  1. Remove the fuel pipe clamp.

  1. Pinch the tube connector, and then pull the fuel pipe out of the pipe as shown in the illustration.

    NOTICE:
    1. Remove any dirt and foreign objects from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected part by covering it with a vinyl bag after disconnecting the fuel tube.
    6. If the fuel tube connector and pipe are stuck, push and pull to release them.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


A075657E01
  1. Remove the 2 bolts, then remove the fuel pressure regulator.

  1. Remove the vacuum hose.