REAR BUMPER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR BUMPER BAR |
![]() |
w/ Towing hitch:
Disconnect the 2 No. 3 wire frame connectors.
Loosen 2 bolts A.
Remove the 8 bolts.
Disengage the 2 pins and remove the rear bumper bar.
![]() |
w/o Towing hitch:
Disconnect the 2 license plate light connectors.
Loosen the 2 bolts.
Remove the 4 bolts.
Disengage the 2 pins and remove the rear bumper bar.
| 3. REMOVE REAR BUMPER SPOILER LH (for X-Runner) |
![]() |
Using a clip remover, remove the 2 clips.
Remove the screw.
Disengage the 4 clips and remove the rear bumper spoiler.
| 4. REMOVE REAR BUMPER SPOILER RH (for X-Runner) |
| 5. REMOVE REAR BUMPER COVER |
![]() |
w/ Towing Hitch:
Disengage the 3 claws and remove the receiver hitch cap.
![]() |
Remove the 2 bolts.
Remove the hitch ball.
![]() |
Using a screwdriver with its tip in protective tape, disengage the 2 claws and remove the rear bumper cover lower.
![]() |
Remove the 4 bolts.
Disengage the 4 claws and remove the rear bumper cover.
![]() |
Remove the 2 nuts from the rear bumper bar.
| 6. REMOVE REAR BUMPER PLATE |
![]() |
Remove the 3 clips.
Disengage the 14 claws and remove the rear bumper plate.
| 7. REMOVE REAR BUMPER BAR REINFORCEMENT SUB-ASSEMBLY (w/o Towing Hitch) |
![]() |
Remove the 10 bolts and rear bumper bar reinforcement.
| 8. REMOVE REAR BUMPER ARM SUB-ASSEMBLY LH (w/o Towing Hitch) |
![]() |
Remove the 2 bolts and rear bumper arm.
| 9. REMOVE REAR BUMPER ARM SUB-ASSEMBLY RH (w/o Towing Hitch) |
| 10. REMOVE RECEIVER HITCH BRACKET SUB-ASSEMBLY (w/ Towing Hitch) |
![]() |
Disconnect the 2 license light connectors.
Remove the 10 bolts and receiver hitch bracket.
| 11. REMOVE NO. 3 FRAME WIRE (w/ Towing Hitch) |
![]() |
Using a clip remover, remove the 2 wire harness clamps.
Remove the 2 bolts and No. 3 frame wire.
| 12. REMOVE REAR BUMPER PLATE LH |
![]() |
Remove the 2 nuts.
Disengage the claw and remove the rear bumper plate.
| 13. REMOVE REAR BUMPER PLATE RH |
| 14. REMOVE REAR BUMPER BAR CORNER REINFORCEMENT LH |
![]() |
Remove the 4 bolts and rear bumper bar corner reinforcement.
| 15. REMOVE REAR BUMPER BAR CORNER REINFORCEMENT RH |
| 16. REMOVE LICENSE PLATE LIGHT ASSEMBLY |
![]() |
Remove the screw.
Disengage the claw and remove the license plate light.
![]() |
Remove the bumper moulding mounting plate from the license plate light.
![]() |
Remove the nut from the rear bumper bar.