COMPRESSOR > INSPECTION |
| 1. INSPECT MAGNET CLUTCH ASSEMBLY |
![]() |
Inspect the magnet clutch assembly.
Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 1 (MG+) of the magnet clutch, and the negative lead is connected to the earth wire.
If the operation is not as specified, replace the magnet clutch assembly.
| 2. INSPECT COMPRESSOR PICK UP SENSOR |
![]() |
Check the compressor pick up sensor voltage.
Connect the positive (+) lead from the battery to terminal 3 (SSR-) and the negative (-) lead to terminal 1 (MG+), and measure the voltage between terminals 1 (MG+) and 2 (SSR+).
When surface A of the compressor pick up sensor is close to the S-pole, the voltage between terminals 1 (MG+) and 2 (SSR+) increases. When it is close to the N-pole, the voltage between the terminals decreases.
If the result is not as specified, replace the compressor pick up sensor.