Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR

COMPRESSOR > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


I044989E01
  1. Disconnect the 2 connectors.

  1. Remove the screw and the cooler bracket.



2. REMOVE COMPRESSOR PICK UP SENSOR


I044990E01
  1. Remove the screw and the compressor pick up sensor.



3. REMOVE PRESSURE RELIEF VALVE


I044998E01
  1. Remove the pressure relief valve and O-ring.



4. REMOVE MAGNET CLUTCH ASSEMBLY


I044991E01
  1. Using SST, hold the magnet clutch hub.

    SST
    09985-00260  

  1. Remove the bolt, magnet clutch hub and compressor spacer.

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.



    I044993E01
  1. Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Take care not to damage the seal cover of the bearing when removing the snap ring.



    I045077E01
  1. When the magnet clutch rotor and snap ring are difficult to remove, use a plastic hammer to tap them off the shaft.

    NOTICE:
    Be careful not to damage the pulley when tapping the rotor.



    I044995E01
  1. Remove the screw and separate the wire harness.

  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.