Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE DEFROSTER NOZZLE ASSEMBLY LOWER


    I043920E01
  1. Remove the 4 bolts and the defroster nozzle assembly lower.



2. REMOVE HEATER TO REGISTER CENTER DUCT


    I043921E01
  1. Remove the 2 bolts and heater to register duct center.



3. REMOVE NO. 1 AIR DUCT


    I043922E01
  1. Remove the bolt.

  1. Disengage the 3 claws and remove the air duct.



4. REMOVE AIR FILTER


    I101602
  1. Push down on the 2 tabs and open the filter door.

  1. Remove the air filter.



5. REMOVE MODE CONTROL SERVO MOTOR


    I043923E01
  1. Remove the 3 bolts and mode control servo motor.



6. REMOVE AIR MIX CONTROL SERVO MOTOR


    I043924E01
  1. Remove the 2 bolts and air mix control servo motor.



7. REMOVE AIR INLET CONTROL SERVO MOTOR


    I043925E01
  1. Remove the 2 bolts and air inlet control servo motor.



8. REMOVE HEATER RADIATOR ASSEMBLY


    I043926E01
  1. Remove the 3 bolts and temperature mounting plate.



    I043927E01
  1. Remove the temperature cam.



    I043928E01
  1. Remove the 8 bolts and heater cover case.



    I043929E01
  1. Using "Torx" socket wrench T30, remove the bolt, clamp and heater radiator assembly.



9. REMOVE BLOWER RESISTOR


    I043930E01
  1. Remove the 2 bolts and blower resistor.



10. REMOVE BLOWER MOTOR


    I043931E01
  1. Remove the 3 bolts and blower motor.



11. REMOVE EVAPORATOR CORE


    I043932E01
  1. Remove the 3 bolts and mode mounting plate.



    I043933E01
  1. Remove the mode cam.



    I043935E01
  1. Remove the bolt and heater pivot.



    I043934E01
  1. Disengage the clip and remove the 11 bolts and mode case.



    I045028E01
  1. Remove the evaporator core.

    HINT:
    If a new evaporator is installed, add compressor oil to the evaporator as follows.

    Compressor oil:
    RL-897 or equivalent
    Add 40 cc (1.4 fl.oz.)



12. REMOVE VALVE TO CONNECTOR TUBE


    I045428E01
  1. Using "Torx" socket wrench E10, remove the bolt and valve to connector tube.

  1. Remove the 2 seal washers from the air conditioning tube assembly.



13. REMOVE EXPANSION VALVE


    I045430E01
  1. Using "Torx" socket wrench T25, remove the 2 bolts and expansion valve.

  1. Remove the 2 seal washers from the expansion valve.



14. REMOVE COOLER THERMISTOR SENSOR


    I045030E01
  1. Disengage the 2 clamps and remove the cooler thermistor sensor.



15. REMOVE NO. 1 COOLER UNIT DRAIN HOSE