AIR CONDITIONING UNIT > REASSEMBLY |
| 1. INSTALL NO. 1 COOLER UNIT DRAIN HOSE |
| 2. INSTALL COOLER THERMISTOR SENSOR |
![]() |
Engage the 2 clamps and install the cooler thermistor sensor.
| 3. INSTALL EXPANSION VALVE |
![]() |
Apply sufficient compressor oil to 2 new seal washers and the fitting surface of the expansion valve.
Install the 2 seal washers onto the expansion valve.
Using "Torx" socket wrench T25, install the expansion valve with the 2 bolts.
| 4. INSTALL VALVE TO CONNECTOR TUBE |
![]() |
Apply sufficient compressor oil to 2 new seal washers and fitting surface of the valve to connector tube.
Install the 2 seal washers onto the valve to connector tube.
Using "Torx" socket wrench E10, install the air conditioning tube assembly with the bolt.
| 5. INSTALL EVAPORATOR CORE |
![]() |
Attach the evaporator side seal to both sides of the evaporator.
![]() |
Attach the evaporator top seal to the upper side and the evaporator bottom seal to the lower side of the evaporator.
![]() |
Align and apply the expansion valve seal to the periphery of the expansion valve protrusions on the back side of the expansion valve.
![]() |
Align and attach the 2 different seals to the evaporator inlet and outlet pipes.
![]() |
Install the evaporator core.
![]() |
Install the mode case with the clip and 11 bolts.
![]() |
Install the heater pivot with the bolt.
![]() |
Install the mode cam.
![]() |
Install the mode mounting plate with the 3 bolts.
| 6. INSTALL BLOWER MOTOR |
![]() |
Install the blower motor with the 3 bolts.
| 7. INSTALL BLOWER RESISTOR |
![]() |
Install the blower resistor with the 2 bolts.
| 8. INSTALL HEATER RADIATOR ASSEMBLY |
![]() |
Apply the heater core short seal to both sides of the heater core.
![]() |
Apply the heater core long seal to the upper and lower sides of the heater core.
![]() |
Apply the heater core header seal to the right side of the heater core.
![]() |
Using "Torx" socket wrench T30, install the heater radiator assembly with the bolt and clamp.
![]() |
Install the heater cover case with the 8 bolts.
![]() |
Install the temperature cam.
![]() |
Install the temperature mounting plate with the 3 bolts.
| 9. INSTALL AIR INLET CONTROL SERVO MOTOR |
![]() |
Install the air inlet control servo motor with the 2 bolts.
| 10. INSTALL AIR MIX CONTROL SERVO MOTOR |
![]() |
Install the air mix control servo motor with the 2 bolts.
| 11. INSTALL MODE CONTROL SERVO MOTOR |
![]() |
Install the mode control servo motor with the 3 bolts.
| 12. INSTALL AIR FILTER |
![]() |
Install the air filter.
Engage the 2 tabs and close the filter door.
| 13. INSTALL NO. 1 AIR DUCT |
![]() |
Engage the 3 claws and install the air duct.
Install the bolt.
| 14. INSTALL HEATER TO REGISTER CENTER DUCT |
![]() |
Install the heater to register duct center with the 2 bolts.
| 15. INSTALL DEFROSTER NOZZLE ASSEMBLY LOWER |
![]() |
Install the defroster nozzle assembly lower with the 4 bolts.