Home › BODY › EXTERIOR › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL BACK DOOR OUTSIDE MOULDING SUB-ASSEMBLY


    B087667E01
  1. Install new No. 3 body outside moulding pad in the position shown in the illustration.



    B087668E01
  1. Install each clip in the position shown in the illustration.

    NOTICE:
    If you install the clips wrongly, the installation of the back door outside moulding would be improper.



    B087669E01
  1. Engage the 3 clips and install the back door outside moulding.



    B087665E01
  1. Tighten the 3 screws.



2. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY


    B087662E01
  1. Install new No. 2 body outside moulding pad in the position shown in the illustration.



    B087663E01
  1. Install each clip in the position shown in the illustration.

    NOTICE:
    If you install the clips wrongly, the installation of the body rocker panel moulding would be improper.



    B087664E01
  1. Engage the 3 claws and install the body rocker panel moulding.



    B087660E01
  1. Tighten the 3 screws.



3. INSTALL ROCKER PANEL MOULDING


    B087657E02
  1. Install new No. 1 body outside moulding pad in the position shown in the illustration.



    B087658E02
  1. Install each clip in the position shown in the illustration.

    NOTICE:
    If you install the clips wrongly, the installation of the rocker panel moulding would be improper.



    B087659E01
  1. Engage the 9 clips and install the rocker panel moulding.



    B087655E01
  1. Tighten the 4 screws.