ROCKER PANEL MOULDING > REMOVAL |
| 1. REMOVE ROCKER PANEL MOULDING |
![]() |
Remove the 4 screws.
![]() |
Apply protective tape to the outer circumference of the rocker panel moulding, as shown in the illustration.
Using a moulding remover, disengage the 9 clips and remove the rocker panel moulding.
![]() |
Turn the clips 90° clockwise and remove them.
| 2. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY |
![]() |
Remove the 3 screws.
![]() |
Apply protective tape to the outer circumference of the body rocker panel moulding, as shown in the illustration.
Using a moulding remover, disengage the 3 clips and remove the body rocker panel moulding.
![]() |
Turn the 90° clockwise and remove them.
| 3. REMOVE BACK DOOR OUTSIDE MOULDING SUB-ASSEMBLY |
![]() |
Remove the 3 screws.
![]() |
Apply protective tape to the outer circumference of the back door outside moulding, as shown in the illustration.
Using a moulding remover, disengage the 3 clips and remove the back door outside moulding.
![]() |
Turn the clips 90° clockwise and remove them.