FRONT DOOR BELT MOULDING > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR FRAME BRACKET LOWER GARNISH |
w/ Power Window:
Remove the front door frame bracket lower garnish .
w/o Power Window:
Remove the front door frame bracket lower garnish .
| 3. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL SUB-ASSEMBLY (w/ Power Window) |
for Double Cab:
Remove the front door armrest base upper panel sub-assembly .
for Access Cab and Regular Cab:
Remove the front door armrest base upper panel sub-assembly .
| 4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Pull out the snap ring with a cloth as shown in the illustration, then remove the door window regulator handle assembly.
![]() |
Remove the window regulator handle plate.
| 5. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY |
w/ Power Window:
Remove the front door trim panel assembly .
w/o Power Window:
Remove the front door trim panel assembly .
| 6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Disconnect the outer rear view mirror connector (w/ Power mirror).
Remove the 3 nuts.
Disengage the claw and remove the outer rear view mirror.
| 7. REMOVE FRONT DOOR BELT MOULDING |
![]() |
Apply protective tape to the outer circumference of the front door belt moulding, as shown in the illustration.
Using a moulding remover, disengage the 5 claws and remove the front door belt moulding.